Automotive Bus Systems Basics Trainer

It is ideal for introduction into networked systemsin modern vehicles. It has two transmitter and receiver units. This system is specifically designed to teachbasics of bus technology. Each unit can begiven an address, such as those used in automotive ECUs. These messagescan be measured with an oscilloscope and recorded. On the receiver side 8 outputs can be connected to LED's, which correspond to a typical vehicle lighting. The transmitter can becustomized 2 x 4 bits to send messages over a single bus line. 

Course Contents:
Assign and transmit data in binary modebinary number system conversion of values, bit significance LSB / MSB addresses
Hexadecimal, conversion of binary values inhexadecimal address assignments
Bus Electrical Systems, topology
Driving a vehicle lighting in differentsituations by sending different messages to their respective receivers via asingle cable
Serial communication, information packetswith address and data blocks, processing
Collisions of data packets
Using the oscilloscope, identifying andinterpret messages.

Components:
1 x Transmitter unit with transparent windowto Interior
1 x Receiver unit with transparent window toInterior incl. 8 control LED's
3 x Switch for sending
8 x Data switch
16 x Address switch
2 x Data cable connectors
2 x Power sockets 12V DC
8 x Signal outputs
12 x LED's in printed vehicle with 8connection terminals.